How to use water circulation vacuum pump？
When using the new pump for the first time, first remove the vent plug and connect the suction tube to the suction hole. Connect the vacuum pump motor with a 4*2.5 three-core cable.
Fill the tap water from the vent to the water tank until the water level reaches the upper drain.
Open the compressor inlet pipe and the upper drain valve, and turn on the motor in the clockwise direction to normal.
The water level in the water tank is often observed during normal use, and the water level must be kept above the compressor inlet pipe. Otherwise, the inner seal of the compressor is easily burned because the water level is too low.
When entering the winter, the icing phenomenon in the workshop should prevent the occurrence of icing in the compressor in advance. You can add antifreeze in the water tank or turn off the compressor inlet pipe after work every day and open the compressor drain to put a net compression. There is residual tap water in the machine.
How can we extend the life of woodworking engraving machines?
Long-term placement of unused engraving machines should be maintained regularly.
Clean the woodworking engraving machine countertops in time after work every day.
Regularly lubricate the woodworking engraving machine guide rails.
Change the clean cooling water frequently.
Choose a working environment that is dry and free of large electromagnetic interference.
The software of the woodworking engraving machine should be upgraded regularly, and the virus should be regularly checked and the virus database upgraded.
why need dust collector system？
When the machine is processed, a lot of dust will be generated. If it is not processed, it will float to various places of the machine, such as guide rails, gear gaps, etc. Many are unable to clean up in time, which creates a hidden danger to the machine. After using the vacuum cleaner, most of the dust damage can be avoided.
Although many operators wear masks, a lot of wood chips and powder float in the air, and the damage to the human body is still great without vacuuming.
Woodworking vacuum cleaner is not expensive, it is better to install it better.
How to prevent water-cooled spindle motor engraving machine waterway blockage?
First, we need to change the water circulation water regularly, so that the water flowing through the water circulation route maintains a certain degree of clarity, and does not cause blockage due to too much impurities and scale.
Packing a filter on the water outlet of the pump can effectively reduce the impurities entering the spindle of the engraving machine. The impurities are less than the water circulation pipe in the main shaft. Naturally, it is not easy to accumulate impurities and scale.
If the water circulation of the main shaft is blocked, the solution is not difficult. You can use the air blowing pipe of the air compressor to connect the spindle inlet pipe of the CNC engraving machine, blow it for a while, then connect the pump with water to flush out some scale. Once, you can clean most of the scale and rust in the pipeline.
Copyright © Shandong Yaxinhua CNC Equipment Co., Ltd. All Rights Reserved | Sitemap | Powered by